Silicone mold making part 2

Good morning! The work has finally begun and I will take my time to realize it. There’s no hurry and I don’t want to skip any steps. When pouring silicone, each corner of the silicone moulds must be properly glued with hot glue to avoid unnecessary spillage. Not to mention that I have to clean and remove any traces of dust on the surface of each molds. Otherwise, I’m going to end up with parts full of reproductive defects. And I want to avoid that nasty surprise. Silicone is a very expensive high-end product!

Bon matin! Le travail à enfin débuté et je vais prendre mon temps à le réaliser. Rien ne presse et Je ne veux pas sauter d’étape. Chaque coin de moules doit être correctement collé avec de la colle chaude pour éviter tout déversement superflu de silicone lors du coulage de silicone. Sans oublier qu’il me faut nettoyer et enlever toute trace de poussière sur la surface de chaque pièce. Sinon, je vais me

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.